Definitions of Square Dance Calls and Concepts
 
Definitions of Square Dance Calls and Concepts
 
 

 This page is still being implemented! 
Try again at a later date.
From 8-dancer formations consisting of 4 outside dancers and 4 inside dancers.

The inside 4 dancers work together to do the given call but end on the outside, as the outside 4 dancers work together to do the given call but end on the inside.

Cross Concentric is the same as Concentric [C1] except that the inside dancers end on the outside, and vice versa.

Shape-changing rules for Concentric also apply to Cross Concentric. Details are given below, in the 'Shape Changing' section.

Notes:

Cross Concentric Turn & Deal:

 
 
before
Cross Concentric Turn & Deal
 after
Cross Concentric Recycle:

 
   
before
Cross Concentric Recycle
 after
Centers Cross Concentric Recycle
& Ends slide in
 after
New Centers Recycle
(done)

Shape Changing rules

  1. If the given call ends in a 1x4, a Diamond, or a Single 1/4 Tag, then there is only one possible ending formation.

    1. A 1x4 is split in half, and distributed as two 1x2 formations on opposite sides of the inside dancers.
    2. A Diamond or Single 1/4 Tag is split into 4 pieces, and distributed like the points of a Galaxy.
  2. However, if the given call ends in a 2x2, there are two choices:

    1. If the given calls starts in a 2x2, the Lines-to-Lines, Columns-to-Columns rule applies.

      Each Center dancer determines whether their starting position within the overall formation is Lines or Columns. If starting as if Centers of Parallel Lines, they must finish as if they are Ends of Parallel Lines. If starting as if Centers of Columns, then they must finish as if they are Ends of Columns.

      The final formation may not actually be Lines or Columns, since dancers can be T-Boned.

    2. If the given call does not start in a 2x2, the Long Axis rule applies. That is, original centers end in outside positions perpendicular to the long axis of the starting formation.

      Only the original center 4 dancers need to concern themselves with this, as there is only one possible ending position for the original outsides.

      1. Upon hearing the words 'Cross Concentric', look at your formation and determine the long axis before you start to move, in case the given call ends in a 2x2.

        1. First, look only at the inside 4 dancers. If there is a long axis, use it!
        2. Otherwise look for the long axis of the overall 8-dancer formation.
        3. If no long axis (e.g., a Butterfly formation), look at the footprints of the Original Outside 4.
      2. Cross Concentric <anything> = Cross Concentric <nothing> + Concentric <anything>.

        The ending position of the call should be the same whether the Cross Concentric is done at the beginning or ending of the call.

        For example, from Parallel Waves after 1/2 Circulate:
        Cross Concentric Recycle = Cross Concentric Nothing + Concentric Recycle.
      3. Another reason for the Original Centers to prefer their 4-dancer long axis: From unusual formations, it's easier to determine the long axis for a 4-dancers than 8-dancers, especially if phantoms are involved.
      4. The ending location of the Original Centers should not be dependent upon the starting location of the Original Outsides. For a call such as Recycle, the Original Centers should always end side-by-side as a Couple, regardless of where the outsides started.
CONTRAST THE FOLLOWING:

Cross Concentric Recycle:

 
 
before
Cross Concentric Recycle
 after
Cross Concentric Recycle:

 
 
before
Cross Concentric Recycle
 after
In both cases above, the original Centers end side-by-side as a couple.

Cross Concentric Drop In:

 
 
 
RIGHT
 
 
WRONG
 
   
before
Cross Concentric Drop In
  after  This ending formation is wrong
because the long-axis for the original
Center Diamond did not change

See also Concentric CONCEPT [C1].

https://www.ceder.net/def/crossconcentric.php -- Copyright © 2024 Vic Ceder.  All Rights Reserved.
full URL